Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
Maytag front load washer door locked flashing.
First it had a code blinking that i looked up and it was for the water so i turned it on and now it is making a humming noise and the door is locked and that is all it will do.
With a 10 year limited parts warranty 1 you can trust that a maytag front load washer has the power and perseverance to keep your clothes clean load.
If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
Reconnect power to washer plug in.
During this period you will be able to hear the pump running.
The door lock led light will blink.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve.
To unlock the controls press and hold the cycle end signal for 3 deliberate seconds or until the control lock light goes out.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Shop maytag front load washers to find options like the optimal dose dispenser so you only use as much as you need a sanitize cycle and even compact models with a stainless steel wash basket.
Nothing else will appear to be happening with the machine during this time.
The door may immediately unlock.
After 8 minutes the door will unlock.
The washer will go into a hold and drain routine for 8 minutes.
This is all it will do.
Click here for more information on how to unlock your washer door when locked at the time of installation were you using a fresh hold cycle available on some models.
The door should unlock after 60 seconds.
Run a drain and spin cycle.
In some circumstances your new washer may arrive with the door locked.
If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor.
Pull on this tab to manually unlock the door.
Maytag washers 3 answers from these members.
Wait approximately 2 minutes for control to reset.
This can occur from the normal shipping movement.
The lid will lock and the machine will enter a pump out mode for 8 minutes.
Now you can reach down to the bottom of the door latch where there is a 1 round plastic tab.
The door lock light is blinking on my front load maytag maxima.
This happened when i forgot to turn the water on.
The top panel will then pull straight back up and off.
